7 in 1 Sets

AdvanceAmayaBarudanBrotherHappyJapanMelcoSWFTajimaToyotaZSK

Advance

 

Amaya

 

Barudan

 

Brother

 

HappyJapan

 

Melco

 

SWF

 

Tajima

 

Toyota

 

ZSK

Fast Frames 7in1 is a hoop less embroidery frame.

Firstly, backing stick on is placed on the underside of the frame. Secondly, the adhesive backing is placed in the open sew space of the frame. Thirdly, and most importantly, that press the area to be sewn firmly down on the backing. (Using the notches as line up points for alignment) however any area that will lay down flat in the sew field you can sew embroidery on.

Fast Frames 7 in 1
Fast Frames 7 in 1

After that, use it for sweat band area of caps, back, sides, bill, bucket caps, collar tips, cuffs of sleeves, dog collars, gym bag center flaps, etc.

Sports fabric in jersey does not get out of shape. Because backing stick on keep it in place. The conclusion, this is much faster, more effective and cost low cost to sewing on.

Don’t worry you won’t waste a lot of backing. When you tear the ready item away, then place a patch on the old embroidery hole from the underside. Then you are ready to press the new item in place to sew a new embroidery – this is well thought out.

The difference between Fast Frames 7 in1 and 6 in 1 is the size af the arm. Frames 7 has a arm there are deeper than the 6 and the embroidery field is bigger and that can be an advantage.

General Instructions for using Fast Frames 7in1

  1. Above all, Lay backing under the frame. Cut backing slightly wider than the frame 3/8″ to 1/2″ all around. Using the frame as your gauge, your backing will fit the frame correctly each time.
  2. Turn the frame upside down. Peel the paper from the backing. Place the backing on the frame. Be sure to allow backing to extend past the sides and bottom of the frame. Fold the excess backing over the front edge of the frame.
  3. Attach the frame to the machine arms just as you would one of your hoops. The opening of the frame (with the backing attached) should be coming toward you. Trace your design for proper location. Be sure to leave enough room that the pressure foot does not pinch the garment on the inner edge of the frame.
  4. In conclusion, remove the frame from the machine. After that place item to be sewn on the exposed backing. Smooth fabric on the adhesive backing. Place frame on the machine and embroider.

Fast Frames 6 in 1 frame will work with many different machines, when you upgrade or change machines, often all you need to get up and going again is a new exchange arm. – CLEVERLY thought out.

See different embroidery frames here.